Hi guys, I need your feedback for volume calculation issue
I designed and support a print on chitubox 1.5 and then slice it in photon slicer
It tells me my print need around 50 ml of resin and I fill the vat until almost all my bed was under resin...( could have put a bit more but wanted to avoid getting too close to the fix)
Anyway after few hours and probably 30 % of the print I get no resin anymore ...
Is this then a totally wrong volume calculation?
Is this because the vat can handle much less ??
Is this because the viscosity of my resin is high due to temp?
Many thanks
翻譯年糕
Ty Mansfield
2020-02-24 23:21:33
Francois Lozach
2020-02-24 23:23:53
Francois Lozach
2020-02-24 23:24:17
Brendan Wood
2020-02-24 23:31:10
Francois Lozach
2020-02-24 23:32:28
Brendan Wood
2020-02-24 23:34:03
Brendan Wood
2020-02-24 23:34:49
Francois Lozach
2020-02-24 23:34:56
Brendan Wood
2020-02-24 23:36:43
Francois Lozach
2020-02-24 23:38:25
Richard van Vondel
2020-02-24 23:45:14
Daniel James Menk
2020-02-24 23:49:22
Tobi Altebaeumer
2020-02-24 23:50:01
Hayley Bourne
2020-02-25 00:10:38
Jason Patterson
2020-02-25 00:25:15
Francois Lozach
2020-02-25 00:34:30
Rob Robertson
2020-02-25 04:35:50
Francois Lozach
2020-02-25 05:08:06
Jon Robert
2020-02-25 19:28:47
Tom Sargison
2020-02-25 19:51:02
