Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hello group,

I am running a bit frustrated this weekend at not being able to produce prints so I will request your assistance.

I order my Anycubic Photon along with 500ml of clear resin. Wonderfull, made great prints (other not so great :P but its part of process). After struggling a bit with a hole in the FEP I decided to order new film and more resin (Anycubic Green).

This is were my issues start. I replaced the film and even though I did not remove the plastic cover that comes with it I managed to perfect batches of prints to finish the Clear resin. Then I realized there was the plastic cover so I removed and poured the new Green resin.

From then every print now sticks to FEP regardless of what I do.Reading around for solutions I change the print setting to something more apropriate to that particular resin, I have tensioned my FEP film properly, and I made sure that I have enough temperature (unfortunatelly can't get near optimal at this time of year but I have printed with colder so it should still work) and still it sticks to FEP. Even more odd to me was that in one of my now 6 attempts or so, one of the figures actually stuck to the plate and I got a beatiful Artisan's guild Dwarf perfectly printed. His hands and backpack (separate pieces) on the other side got stuck to FEP.

I am wasting alot of time and some resin with this ? after the last batches of Clear resin I was so happy I finally had a nice setup and was ready to start printing more intesively and another obstacle hinder my way.

Any thoughts on how I can fix this?

Thanks in advance

翻譯年糕

Hey everyone, I have encountered a issue with my Photon that I can't seem to find a solution for around the internets. Or maybe I am not searching properly so I decide to describe it as best I can here, maybe someone has encountered same issue and hopefully as a solution.
After 4 considerably successful first prints, that included a adapter for the vent, I moved printer to her new spot (inside has the balcony as a very cold temperature this time of year but had to do for the first ones),mount vent tube, then recalibrate (set home,then pressed z=0) give a quick test only to near to the end hear some sound and find plate is trying to go further up the axis then it can.
The issue seems to be plate does not set proper where the 0 is. The plate stays where I leave it after raising manually to be able to fit in the vat.
Possibly causes would,my guess related to temperature, but now inside I should nt have a problem if it even printed outside. Also in the last print, i had a incident with the red knob that you unscrew the remove the plate. The knob stayed in my hand and the screw in place and would not budge so I had to unscrew the 4 smaller screws to be able to remove tte plate.
Any help would be appreciated! I was having a lot of fun learning in the process and making my little miniatures and now I am very stuck with this. Thank you in advance!

翻譯年糕