Any hints on removing supports from minatures? Im using the flat edge cutters as recommended, but they just end up shattering the minature into pieces, even if im as gentle as posible... ive tried before curing and after with same results. Could it be the resin or the exposure time (I'm using anycubic grey resin, and the default exposer time in photon slicer, 10 seconds).
翻譯年糕
Sean Guna
2020-02-08 23:09:14
Sean Guna
2020-02-08 23:09:26
Mike Roof
2020-02-08 23:09:26
Brendan Wood
2020-02-08 23:17:49
Jennifer Tallman
2020-02-08 23:21:33
Jim Nelson
2020-02-09 01:08:53
Chef DeSanto
2020-02-09 01:16:56
Scott Pavlich
2020-02-09 02:50:25
Chris Holden
2020-02-09 03:24:27
Chris Thiessen
2020-02-09 04:39:04
James Cachia-Garrett
2020-02-09 05:05:19
Sean Montgomery
2020-02-09 05:22:56
Chef DeSanto
2020-02-10 00:58:13
Peter Anderson
2020-02-10 12:16:53
