Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Keep getting this depression on the bases of the miniatures I’m painting, not sure if it’s a support issue, a raft issue or what, still fairly new at this. These are both with the x axis on 300 degrees (that got them with supports on their back) and I used light supports for the first one (which had the raft itself curling off the plate when it was done) and the other with medium. Any insights?

翻譯年糕

Test print and first miniature (keg golem): SUCCESS. Hella excited to figure out what’s next! What primers do you guys recommend for resin printing (this is just anycubic gray)? Generally use acrylic paints if that matters.

翻譯年糕

Hey guys, first-time printer here, potentially stupid question: I tried the FLint Read method of leveling the plate as reccommended by a friend, and when I go to start the test print the build plate actually submerges beneath the resin, I have no idea if that's SUPPOSED to happen or if just the flat side of the plate is supposed to make contact, worried about wasting a load of resin like that. Is that normal or did I do something incorrect in leveling?

翻譯年糕