Hi folks! Prints are perfectly accurate and precise but I have a problem with popping the printed stuff off the plate. It seems waaaaay too hard and ABSOLUTELY impossible to avoid damaging the plate.
I used the search-in-page function to try to find something about it but no success.
Please, give me an advice or a link!
Thanks!
(I use a silver build plate)
翻譯年糕
Chris Beaumont
2020-03-07 19:26:15
Илиян Илиев
2020-03-07 19:27:58
Chris Beaumont
2020-03-07 19:28:47
Reb O'Rourke
2020-03-07 19:29:18
Paul Metcalfe
2020-03-07 19:34:04
Dave Dewees
2020-03-07 19:44:30
Chris Kilcrease
2020-03-07 20:31:17
Scott Pavlich
2020-03-07 20:56:36
Илиян Илиев
2020-03-07 21:26:02
Илиян Илиев
2020-03-07 21:26:27
Brett VanDyke
2020-03-07 21:37:30
Jacob Palmer
2020-03-07 21:44:55
Keith Yinger
2020-03-07 23:24:31
Keith Yinger
2020-03-07 23:25:59
Mark Wardle
2020-03-07 23:38:37
Jason MeGahee
2020-03-08 00:09:38
Josh Fagan
2020-03-08 00:25:21
Brianw NJcsx
2020-03-08 01:33:35
Jennell Jaquays
2020-03-08 05:44:14
Mike Melcher
2020-03-08 17:37:57
Luke Mason
2020-03-09 15:18:17
Илиян Илиев
2020-03-09 16:24:16