ATOM 3D Printer Group 造訪社團 » 用戶發文

Configuration.h

# define DEFAULT_AXIS_STEPS_PER_UNIT {160, 160, 160, 200}

I only have to change the last number ?

because I changed it to 800 but it didn't extrude further

Thanks

Restore failsafe

actually those value could be changed via LCD menu directly

ok I will try

I have seen some values connected to extruder config in Configuration_adv.h

I thought it might be a better option

the DEFAULT_AXIS_STEPS_PER_UNIT {160, 160, 160, 832} is the perfect set for the titan extruder but now the motor skips steps and it doesn't turns continuously although the amount of extruded filament is right. Is there any other config that can change this motor step skipping ?

# define DEFAULT_MAX_FEEDRATE {300, 300, 300, 500} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {3000,3000,3000,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older v ersions raise them a lot.

#define DEFAULT_ACCELERATION 500 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 9000 // X, Y, Z and E max acceleration in mm/s^2 for retracts

thank you, it still skips a little bit but it is much better !

interesting, but not tried yet.

Do you think it can work?

Thingiverse had about this document

很想測試, 但是看半天實在不確定怎麼接上去, 不然就衝了 =.=

用1n5408

https://www.facebook.com/stevebooth69/videos/10209457835667052/

I put only to the Z, behaves strange

stops before the limit switch and turns back , sometimes the motor turns in the wrong direction from the beginning

https://www.simplify3d.com/....../print-quality....../......

configuration.h
const bool Z_MIN_ENDSTOP_INVERTING = true; // set to true to invert the logic of the endstop.

try another browser, sometimes it's strange on some browser

ok , thanks

http://www.atom3dp.com/wp....../uploads/2016/01/ATOM3DP.zip

Try this one, and don't forget to "select profile" after importing the FFF profile

Thank you!

G29 z+4
Change to z-6
https://atom3dp.squarespace.com/basics-of-kisslicer-1/

Thanks, it works!

can you show me your custom print head?

unfortunately no, because it looks extremely ugly, but if i make it nice I will, sorry

actually you could set probe offset in marlin configuration.h
There's an option there for this

thanks , initialy i was asking for that, because I did't manage, but it worked this way, too