管理員
統計數據
原文網址 Harry Cayne 2015-08-04 03:29:57
hello! did anybody tried this software : http://www.mattercontrol.com/ ?
原文網址 Harry Cayne 2015-07-25 02:03:04
Hello! my Atom 2.0 is not printing in level, the back part (closer tot the Z axes) is lover (about 0.3 mm) than in the front, is there any solution for this? I've tried to put some tape under the glass but it didn't help after auto level it is printing the same way. I've checked the aluminium extrusions and the corner pieces there are almost no gaps (maybe under 0.1 but I can't push tighter). Thanks
Clarence Lee 2015-07-25 09:25:49
check the z min endstop screw tenstion check the wires length on the effector, make sure it's not too shirt when G29. If possible , upload a video running G29.
Harry Cayne 2015-07-25 23:25:14
thank you for the quick reply, I've checked the endstops everything seems ok, I also made a video , ( https://www.dropbox.com/....../AADtifVMPvNpTR521jd3Wyl...... ). I made an experiment which worked I have put a 1.5mm thick cardboard piece under the back part ( near Z axe) while it was doing the G29 and when it started to print I took it out and it worked perfectly in level. Do you think it can be compensated by the arduino software ? Thanks
Rickey Yang 2015-07-25 23:53:49
your fan mounted in the wrong direction
Harry Cayne 2015-07-26 02:33:42
Ok in the meantime I realized you are right I will turn it because it blows in the front instead of down
討論主題
全不選 常用關鍵字
