ATOM 3D Printer Group 造訪社團

印匠家有賣啊！而且比較便宜。　有買了一卷一直沒有用，因為噴頭都沒事ＸＤＤ

噴頭不順換掉就好了?

。。。。。我是覺的不需要。。。。。。

這造型，用PLA＋ABS支撐是不是也可以。
https://goo.gl/XrSXiN

應該可以。
支撐材其實仍是PLA，PVA只是用在支撐材與工件之間的隔絶與實心支撐層。

ABS會醺死人哪⋯⋯還要熱場保溫

話說這個設計很厲害，想學。

其實我會想把框跟面板分開印，框水平印，面板站著印，裝的時候用框去套住面板跟手機。這樣也可以變成四種顏色。

Nice job - I have not yet tried using Attractor Points but it's on my list of things to do. Here's a blog page I've posted about the benefits of paramtric modeling and Grasshopper: http://birkbinnard.com/blog/parametric-modeling/

老師一台暖爐ABS很好印 我都這樣哈哈哈哈哈

我這邊有設定檔，不知道是不是你需要的

先截個切片參數的設定來吧，可以幫抓蟲

那東西滿難壞的... 除非你動過噴頭 才會逼緊壓碎
我覺得應該是熱敏... 用電錶量看看阻值

螢光料

快接頭的品質也很重要阿 有些爪子的耗損速度 不敢恭維

我發現要回收這堆米粉有些困難......

看這個圖，好像是這卷料捲的問題比較大。

G29 是指Bed leveling嗎？

我覺得差別在第一層，如果做完Bed leveling，offset又設0，因為噴頭跟平台沒有間隙，所以第一層就出不太來，我習慣會設0.1

好的開始是成功的一半，所以 G29 完會再 adjust offset 一次，之後切片會改那個值，就不用再改了。

我的做法是：做g29之前，offset設置為0，做g29之後，再做adjust offset ^_^

You could email Atom.

記得至少要120cm阿～ 直接載入官方CURA設定吧！ 比較快～

97不能再多……
你怎可以不用換料柱

gcode沒問題的話就是韌體改壞了XDDD

Nice work! But a little bit under-extrusion. I would like to recommend that you could change PTFE tube which in the hotend.

It's the image processing done by Facebook that makes it look under extruded. In real life the part looks excellent - almost as good as injection molding. There is some stringing on the inside, but even that is fairly minor.

The PTFE tube inside the h otend is OK - I recently had the hotend disassembled to clear a jam, and the tube looked fine. I've found that I get good results by ignoring the recommended length for the tube and instead push the PTFE as far down into the hotend as possible and then cut it off even with the top of the connector to which the Y adapter connects.