Hi, I’ve had a lot of great prints on my Photon but lately they haven’t been as great and I’m hoping the hive mind could give me a few suggestions on how to get the prints back to where they were.
Resin is Egloo Grey
Settings are
Bottom layer exposure 90
Bottom layer # 8
Exposure 15s
I came to these setting my running the exposure test.
Both images have the same settings except the first one also has the Exposure Off at 1 second for some reason. I don’t remember putting that on there but looking back at the file settings I caught that.
First print has a strange line of resin partway through the print. Also looks like some of the parts are chopped in half where this resin line is.
Second print looks (to my untrained eye) like it’s pulling off the build plate uneven. I’ve re-leveled the build plate and will try again on this one. This one does not have the resin off setting. Not sure if I need that or not.
I’m printing indoors so I don’t think temperature is a factor.
翻譯年糕
Janus Stark
2020-02-16 22:05:18
Adam Shield
2020-02-16 22:09:00
Dan Gump
2020-02-16 22:09:43
Janus Stark
2020-02-16 22:11:01
Dan Gump
2020-02-16 22:12:15
Chris Beaumont
2020-02-16 22:17:55
Janus Stark
2020-02-16 22:19:43
Chris Beaumont
2020-02-16 22:22:57
Dan Gump
2020-02-16 22:23:43
Jason Pedersen
2020-02-16 22:40:14
Chris Holden
2020-02-16 23:50:38
Arthur White
2020-02-17 00:25:53
Jacob Palmer
2020-02-17 00:33:48
Dan Gump
2020-02-17 00:37:51
Jacob Palmer
2020-02-17 01:12:52
Alan Bullard
2020-02-17 04:55:03
Matt Houghton
2020-02-17 07:24:18
Matt Houghton
2020-02-17 07:25:19
Dan Gump
2020-02-17 07:28:17
Matt Houghton
2020-02-17 08:04:37
