Anycubic Photon Printer Owners 造訪社團 » ROS

Strange horizontal line across each of these figures. It’s a lot harder to see on the figure on the right, but it’s there. They are both at different heights on the z-axis though. What’s the likely culprit of these?

No pauses, opening the door, or anything during either print job.

翻譯年糕

Boa tarde.
Alguém poderia me explicar ou me passar um link de configurações sobre resolução e os outros parâmetros pra quamdo for imprimir conseguir o melhor resultado.
Precisa fazer um update no firmware ou fico com o que veio?
Agradeço desde ja.

翻譯年糕

Curious if anyone can shed some light on this. My prints are coming out pretty good on all sides except the "bottom", which is coming out a blobby mess.

The first pic shows the bottom of a partially painted figure, and you can see up towards the top everything is crisp, and on all other sides of the figure, the detail is sharp, but around the treads and the lower body its very blob-like.

The second photo shows the image in Chitubox - printed upright but on a platform of supports.

The third shows the print settings. Anyucubic Green resin.

This has been true across pretty much everything I've printed. Thoughts? Or is this just the way it is?

翻譯年糕

Thoroughly annoyed. Has anyone ever had their Monocure Platebond bottle split open? Mine did and leaked its contents across my desk last night. That's £30 down the drain! had hardly used it ?

翻譯年糕

I completed the sagrada-familia project.

I installed hollow and dig holes by mesh- mixer and installed supports by chitubox and B9creator.
The B9creator works well with the support of a very fine overhang (star, cross).

Thin, wide and flat pieces were rotated by 10 to 15 degrees by mesh- mixer. Outputting horizontally may cause the platform to fall during output.

I printed out all five pieces and completed the entire model with adhesive.

The color will be painted slowly.

STL name is 'sagrada-familia-complete-barcelona'

翻譯年糕

How different are .photon files from .photons files?

I know they are not cross compatible, but they both use image slices, and Chitubox can read and write both types of files. Is the difference between them really as huge as some state, or is the difference just in the commands used to tell the machine what to do?

翻譯年糕

So I've checked the "Resin Roster Resource" spreadsheet...has anyone used Form Labs White in their Photon. If so, what settings? I've got a liter of this stuff not being used.......yet ?

翻譯年糕

So I haven't really gotten around printing much recently, but just came across this video by chance.
Perhaps it's some interesting information for some?

翻譯年糕

Hello guys, I created a patreon page where I'll share my miniatures while I'm learning the sculpting of minis. I also have some free mini on gumroad.

https://www.patreon.com/simonaublet

I'll print the Law Knight with a gun tomorow, finger crossed !

翻譯年糕

I tried to print two files today: first the "Rear Vent to 4" Adapter for Anycubic Photon" file from Thingiverse, it failed almost immediately. Is even really possible to print this file on the Photon? My next failed print were "name plates" the frames printed just fine but the initials printed very faintly and then oddly across the top of the frame in a different plane. Any ideas? The slice and the stl all are "right".

翻譯年糕