Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Mariusz Ciepieńko
2020-03-09 23:39:36

Guys, what do you think? How it could happen? It looks like broken but there was almost no signs on fep film. 4s 0.05mm layer.

翻譯年糕

Mark Wardle
2020-03-10 00:12:15

原文網址 Mariusz Ciepieńko
2020-02-27 20:49:46

About green transparent resin from Anycubic - there is a time range for each layer from 3 seconds to 15 seconds. Have you ever tested such a short time for this?

翻譯年糕

Scott Pavlich
2020-02-27 20:58:04

Niall Forrester
2020-02-27 21:27:34

Mariusz Ciepieńko
2020-02-27 21:29:27

Niall Forrester
2020-02-27 21:29:54

原文網址 Mariusz Ciepieńko
2020-02-23 01:26:05

Guys,
When I shake a resin bottle before use, it generates lots of bubbles. What do you think, does it affect anything during print?

翻譯年糕

Jaco Norchie Nortje
2020-02-23 01:27:42

Rose Stumpwater
2020-02-23 01:28:27

Janus Stark
2020-02-23 01:29:41

Tim Moulton
2020-02-23 01:30:50

Paul West
2020-02-23 01:35:21

Robert Maefs
2020-02-23 01:44:08

Gary Carone
2020-02-23 04:47:18

原文網址 Mariusz Ciepieńko
2020-02-17 18:07:33

Hello,
I am trying to print some samples from ISO 572-2 but still have problems - most important issue is that the border nearest to platform is not sharp. I forgot to make photo but it is like a wave... don`t have idea how to name it.

I need to print this sample with different orientations and configurations - do you have any ideas how to create support structure for this task? Or anything what could help?

I tried also to print it horizontally, but samples stick to FEP film and supports break in a middle :(