Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Elegoo Grey. ? It's pretty consistent even through different stocks of bottles

Siraya fast grey. I’ve gone through 4 liters and the 5th is on order.

The e-sun washable white has given me the best results over Anycubic, Eryone and Elegoo.

The anycubic green was good to me, but didn't work well for what I print on the machine. Elegoo abs-like has also worked great and is now my go to.

ToAuto

Monocure Clear gives me great results

Siraya tech fast grey

Elegoo is good, but I get Anycubic becuase it is cheap and it works

if you get the cheaper elegoo it is way cheaper and about the same quality as anycubic green if not maybe a little better
30$ instead of 65? yes please....

I have only used Anycubic green and transparent. Both give great results.

I'm using the Elegoo water washable Gray and I've had no issues with it.
Print quality is great and for the obvious, its food that you only need water to clean your prints.

Anycubic grey mixed with tenacious or blue. Every time I use it up or dump it back into the bottle I switch to the other one. Keeps it tough and right now I am just about finished printing a slightly larger than ancient red dragon

Tried several Anycubic colours so far all with successes. Grey is my most used though

I had fantastic exp with Elegoo Gray, reasonable with Sain Smart(brittle), and Monoprice has just pissed me off with fails non stop.

All of them

Yep. Same!

If you have patience and don't mind doing the post cure in water. Siraya ABS like yellow. Takes about 18s exposure though.

Nova3D transparent green turned out by far my best.
Green resin in general is the fastest curing, because green absorbs UV light best

What's the most flexible resin you have used? Want to make frames for medical shields.

Monocure works great for me

Eileen Forman monocure flex100

Anycubic trans green is my fav, with primer

Cannabis one, best results I have ?

anycubic grey

Anycubic black and skin.
Monocure i trashed 2 liters, cheap scrap.

Siraya Tech Fast

Anycubic green and elegoo gray are my favorites.

This is my particular go-to as well. I don't keep a meticulous ratio, but I think I'm about 70/15/15 of grey:tenacious:blu. Extra small supports sometimes break away prematurely but I haven't had any major failures.

Yeah about the same ratio just kinda eyeball it

I have good success with anycubic grey, Siraya tenacious and Siraya Blu. I don't keep a meticulous ratio, but I think I'm about 70/15/15 of grey:tenacious:blu blended together. Extra small supports sometimes break away prematurely but I haven't had any major failures.

I've found the cheap/fast/simple style resins are very brittle so the tenacious makes them less risky to handle.

I wish the gray and green weren't completely sold out. Just used up my last bottles of both about two weeks ago, and I miss it so.

Ted Brockwood I just ordered some last week. Keep an eye out and set up notifications if you can for when it comes back in stock!

Siraya Tech Fast Grey or Black

All water washable versions:
Polyjuice translucent blue and clear, Elegoo translucent blue, white, and grey.

If you have patience, Siraya ABS like yellow. I top the bottle off with siraya blu and it takes about 18s exposure.

https://monocure3d.com.au/