ATOM 3D Printer Group 造訪社團

you can try to destroy the L1(Diode) in mainboard and make short circuit it.

Okay? Thats an interesting workaround. Something seems to be broken here. Where do I find the diode?

Do you have the power on? The printer is able to be turn on only with the 5v of the USB...

I have detected another bug with last firmware as well, if i turn off the printer with the USB conected to the computer, It shuts off the computer too!

When I turn on the printer (with mains connection) it kind of turns on but without the display. When I plug the USB the display comes on and the works. Where is this L1 diode?

Is it work with USB connection? try printing something to see if it is just the "reprap discount smart controller LCD" should be replaced.

I posted another video. It shows that it works with USB. Whats wrong there?

I had this issue before and it was the display for me. It is either the display or main board. The display is the quickest and cheapest to test first.

定形金剛

加油，期待後續~

有沒有試試拿掉上下層之間的間隙片，只靠剩下的雙面膠來隔開？

我覺得調平的程式有問題，我調完之後反而會撞底板，要重開才會正常

不需要什麼設定檔, 範圍高度設定好就行了, 另外建議用V3就好, V4版會出現列印完成時往下撞列印件的慘劇

+1

設定檔去抄之前用的切片軟體就好啦

目前覺得這東西實在好用，可惜，還沒能找到有效減低它接觸面積增加準度的方案

林柏毅 該跟一波了吧～

強者 大大

等待成果分享^^

OK蹦

豬

發圖不附連結 此風不可長XD

好母湯的模型

這類圖很多吧? 我以為各位紳士們都知道...
不過我都用光固化印就是了.
https://www.thingiverse.com/COLOR3DJP/about

這個概念好！

同款式！擊掌