Anycubic Photon Printer Owners 造訪社團 » LCD

What precautions should a new user take to protect their lcd. I keep seeing post about the lcd being out already or people pulling them out or getting resin on or under them... are they really so delicate

翻譯年糕

Hi guys I am desperate. I had to replace my FEP and after that I am not able to get prints stuck to the Build plate. They gets stuck on the fep. I tried:
- different z0 even completely touching the lcd
- changing resin
I am not sure about the right tension for the FEP it was seeming too tight so I left the screws on the bottom of the vat a little loose. Can this be the reason?
Bottom exp time is 60s

翻譯年糕

hello everyone, my printer broke.
this is the plastic/mica sheet (I'm not sure) under the LCD
anyone have anyidea what is going on ?

翻譯年糕

Loving my Photon so far. Now I'm wondering what options are there for bigger printers in the DLP world? I found the soon-to-be-released Creality LCD-003 which will do 192x120x230mm . Heard mention (but not much else I found) about a Photon X. What else is available or on the horizon and what are the anticipated price points?

翻譯年糕

When a print warps at the edge, is it because of resin? print orientation or polymerization shrinkage?

I printed these two parts flat on build platform for speed and there was noticeable warping at the edges (can see on the pillars/pins).

Would tilting it 20 degrees and print with skate and supports help? Does this happen more with LCD resins?

翻譯年糕

Wow! Even cheaper than the last flash sale!!
£323

ANYCUBIC Photon 3D Printer, LCD Masking Technology with UK Plug (Upgrade Yellow Model)

翻譯年糕

Not sure if my post ever published but, I am having issues getting the lcd touchscreen to come back online after fixing the z-wobble and the panel slipped and broke the holder for the ribbon that connects the touchscreen to the board. Any ideas how I can fix this?

翻譯年糕

I think I just realized why the side of the model facing the buildplate doesnt look -as- good as the one that faces the LCD.

Basically the side facing the LCD is mooshed against the FEP and has a uniform area to cure. Where the space facing the buildplate isnt mooshed and isnt constained outside of the buildplate itself or previous layers.

But there is no way of escaping this limitation outside of well tuned cure times.

翻譯年糕

Hi guys, my printer recently developed lines on the LCD screen. I have never had a FEP film break, so I don’t think it’s from resin. When you scratch a finger nail on it, it feels smooth so it seem it’s on the under side.

Has anyone seen this before? Can anyone help me on why this happened?
These lines show up in my prints and makes them worthless.
Thanks!

翻譯年糕

So when starting my next project t earlier the z axis failed to move and the led/LCD started exposing the first layer immediately.
I stopped the print.
Cleared the vat of exposed resin and started print again.
2nd time of starting z axis moved but didn't go to home then z=0 it just ran right to the bottom and the motor kept running.
Switched machine off and back on, reset z=0 and it's printing fine again.

I've had the first part of the issue previously but cleani6 the vat and started again without issue.
The z axis issue I just had worried me more for fear of breaking the LCD etc.
Anyone else had this issue?
Running a stock photon as it came out of the box. Using the included usb but am aware of the issues with those so I'm ordering a replacement
Purchased just after Xmas and other than this works fine.

Any ideas/suggestions?

翻譯年糕