Hello everyone long time lurker here. So my fep went a couple of days ago, no drama - i have read the posts and watched the how to change videos etc.
What did my head in was the price people are charging for a little bit of plastic.... wtf!!! In no way is it acceptable to charge that amount (anything more than 50p lets be honest) for a peice of mass produced generic plastic sheet that size!!!!
So i started thinking (a one off for me
?
) - it has been mentioned on here before and decided to give it a go ...... laminator sheets!
So first i ran a single sheet through the laminator then tensioned it and installed it in the print tray.. worked fine.
Then i started a 5 hour print.. made all the correct sucky noises and currently 2hour in, all seems fine will let you know how it goes x
翻譯年糕
Sander van Deijl
2020-02-06 01:20:09
Felix Flauta Jr.
2020-02-06 01:20:41
Daniel Lilygreen
2020-02-06 01:23:20
Brett Thompson
2020-02-06 01:24:17
Ray Sears
2020-02-06 01:31:48
Scott Pavlich
2020-02-06 01:40:36
Milton Maxson
2020-02-06 01:49:20
Vinicius Silva
2020-02-06 01:49:38
Brett Thompson
2020-02-06 01:55:10
Yasu Tano
2020-02-06 01:58:27
Vincent Vega
2020-02-06 02:15:53
Matthew O Brien
2020-02-06 02:20:19
Matthew O Brien
2020-02-06 02:26:09
Matthew O Brien
2020-02-06 02:27:13
Matthew O Brien
2020-02-06 02:30:56
Vinicius Silva
2020-02-06 02:53:10
Matthew O Brien
2020-02-06 02:55:33
Ray Sears
2020-02-06 03:01:48
Matthew O Brien
2020-02-06 03:11:37
Stefan Giudici
2020-02-06 04:16:02
Matthew O Brien
2020-02-06 04:35:11
Keith Yinger
2020-02-06 05:23:22
Matthew O Brien
2020-02-06 05:28:28
Gary Carone
2020-02-06 08:13:17
Gary Carone
2020-02-06 08:14:50
Ken Schmitt
2020-02-06 09:07:07
Nick Williams
2020-02-06 09:24:39
Dan Gump
2020-02-06 09:54:17
