Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jacob Neitling
2020-01-01 08:22:06

Any idea what caused the white buildup test file made today. And only thing I can think of would be ipa wash did something after print. It was cured too.

翻譯年糕

Stefan Giudici
2020-01-01 08:23:24

Jacob Neitling
2020-01-01 08:24:07

Mark Wardle
2020-01-01 08:26:49

Karel Svoboda
2020-01-01 08:26:56

Mark Wardle
2020-01-01 08:28:50

Karel Svoboda
2020-01-01 08:30:17

Jacob Neitling
2020-01-01 08:31:08

Mark Wardle
2020-01-01 08:31:32

Karel Svoboda
2020-01-01 08:32:26

Mark Wardle
2020-01-01 08:32:33

Mark Wardle
2020-01-01 08:35:11

Johnny Johnsen
2020-01-01 08:38:11

Mike Fatchett
2020-01-01 08:45:06

Alex Vee
2020-01-01 08:45:23

David Lester
2020-01-01 08:57:14

Stefan Giudici
2020-01-01 12:04:03

Nathan Kopp
2020-01-01 12:15:08

Daniel A Trisler
2020-01-01 12:33:44

Jacob Neitling
2020-01-01 12:59:16

Budiarta Komang
2020-01-01 22:55:53

Gino Goetz
2020-01-02 23:33:56

原文網址 Jacob Neitling
2019-12-30 11:50:11

Looked around didn't see a direct answer om. This. In a resin printer. If you print overnight. In the am is it too late to post process in ipa.? Will resin cure on plate and tank? Indoors 70 degrees F and lights off.

翻譯年糕

Tim Borschel
2019-12-30 11:53:27

Stefan Giudici
2019-12-30 11:55:00

Nathan Lange
2019-12-30 11:56:45

Thomas Kenneth Scheer
2019-12-30 11:57:26

John MacDonald
2019-12-30 12:11:50

Scott Pavlich
2019-12-30 12:19:47

Chad Elstad
2019-12-30 12:22:01

Don Newman
2019-12-30 12:46:38

Ryan Turner
2019-12-31 07:03:00

Richard Shapiro
2019-12-31 11:33:13

原文網址 Jacob Neitling
2019-12-30 04:57:18

OK I know I'm new to resin printers but in all seriousness with fdm I can see a failure in 5 min. Reset and be good how do you the pros in here know it is working and can walk away and not wait for 1 hr or so to look at build plate while it lifts up and then see its failed. I don't wanna waste time if it's bad. Any pro tips. CN I. Somehow edit gcode or equivalent to in 5 min lift up to viable height then let me inspect and then continue? Or am I asking too much of such a low cost printer? I'm sure I can't be only one who has had this question.

翻譯年糕

Cam Erasmus
2019-12-30 04:58:52